|
|
Post by lynx on Jul 1, 2008 17:50:16 GMT
Does anyone use a felder combo machine? Just wondering how much hassle it is to change between machines?
Thanks
|
|
|
|
Post by Enochknew on Jul 1, 2008 19:36:13 GMT
Very little . It will take you as long to read this message .
|
|
|
|
Post by woodworker on Jul 1, 2008 21:42:06 GMT
I had a Felder KF700 SP saw/spindle which was no hassle to change options, lower the saw blade below the table (less than a minute)
lift shaper hood in position, remove captive rings, raise spindle (less than 2 minutes).
I also have a AD7410 P/T which is even easier to change modes, release two kip levers, lift planer table, swing extraction hood into position, connect extraction hose, start machine, (less than 1 minute).
|
|
|
|
Post by modernist on Jul 1, 2008 22:55:39 GMT
I've a Hammer C3/41 which is OK but the combo fence is a compromise and pain being to long for ripping and too unsupported for the surfacer. Moulder is fine and the felder fences are a lot better than the Hammer.
Brian
|
|
