|
|
Post by jonnyd on Jul 26, 2008 16:11:35 GMT
Hi i am looking for an adaptor for my suva guard on my panel saw so i can fit some overhead extraction. The piece needed is a rectangle of around 30mm X 75mm going into a round. The round piece can be 75 or 100mm. Anyone know where to get one from.
Jon
|
|
|
|
Post by jasonb on Jul 26, 2008 16:19:29 GMT
|
|
|
|
Post by jonnyd on Jul 26, 2008 16:45:33 GMT
Thanks Jason I think i could do it with the heatshrink stuff but would prefer a solid piece if it was available.
jon
|
|
|
|
Post by Scrit on Jul 26, 2008 18:14:02 GMT
I'd agree with jason about the heat shrink, although I will add another couple of thoughts. Running a 75mm flexible hose for long distances is never a good idea simply because the ribs inside the hose create massive drag and reduce the effectiveness of the overhaed extraction. I eventually threw away the 75mm flexible hose on my Altendorf and substituted 100mm galvanised steel trunking except at the joints and the connection to the crown guard. It didn't look as nice but it worked a lot better. I only wish I'd read up on the subject at Bill Pentz's site a bit earlier Scrit |
|
