Workshop Wall cupboards - Completed now

[9fingers]

modernist said:

9finger said:

My priorities were to get the dust collection in roughly where machines would go, .

Bob

You must have a hell of an extractor pulling that lot.

Do you have to allow for static?

Hi Brian,
The blower is 14" diameter and 6" diameter inlet/outlet powered by 3hp motor.
There is plenty of suck at each of the 8 inlets (only one blastgate open at a time)
There are no static precautions. Reading around the subject on line you can find opinions varying wildly regarding the severity of static.
After nearly a year of use, the outside of the uPVC pipes have at a fine layer of dust from the atmosphere but so do other surfaces in the workshop so I'm not convinced there are major electrostatic fields present.
The late Barry Burgess did not experience any static problems with the set up before I became the custodian.

HTH

Bob

[jfc]

Very flash mate . Get the power sorted as soon as possible . I've just had mine done after years of changing plugs over from leads and it is a real destresser not having to unplug this to do that but just turn it on .