|
|
Post by druster on Dec 30, 2007 10:48:34 GMT
I recently obtained one of these, badged aptc ct200 and have started to tidy it up for use and discovered that the beds are out of parrallell ie they slump at each end, does anyone know this machine, I know it is still being made and sold in the us by several people. any advice on how to correct problem would be gratefully received.
cheers,
Dru
|
|
|
|
Post by engineerone on Dec 30, 2007 11:34:32 GMT
sorry, don't know, but would suggest that you look for the mounting bolts on each table and see where the adjustments are. this is how most other tables work. paul  |
|
|
|
Post by 9fingers on Dec 31, 2007 8:16:05 GMT
Axinster have manuals online. A quick look shows they have the CT150 which might be similar enough to help you.
I have the Jet 60A 200 mm planer and a manual 'somewhere' if the jet is nearer your machine than the ct150 and you want the manual then please let me know and I'll look it out.
Bob
Later the same day:.....
I've found the Jet manual and there is no obvious adjustment for table droop. The central casting has two dovetail slides machined in and locate within similar dovetails in each table.
I can only assume that they rely on very accurate machining during manufacture.
|
|
