simuk
Full Member
Posts: 111
|
Post by simuk on Jan 6, 2009 21:29:02 GMT
Hello Folks,
I have managed to purchase a Omas 426-2 Door Set from flea bay but unfortunately no instructions. Have e-mail Omas direct but had no replies, anyone no where else I could try?
thanks in advance
Simon
|
|
|
|
Post by lynx on Jan 6, 2009 21:39:17 GMT
Sorry mate, can't help you but I do have a question about these door sets.
Are you only relying on the tongue that is produced, fitted into the groove or do you machine a longer tenon. It's just that I can see these being strong enough, they must be as everyone is using them. Can you use these sets for large 44mm doors with RF panels etc??
|
|
simuk
Full Member
Posts: 111
|
Post by simuk on Jan 6, 2009 21:47:27 GMT
Hey Lynx,
I haven't had a chance to play with yet so not sure about machining longer tongues, the specs for them on axminster say they will accommodate doors from 20mm to 37mm in thickness
|
|
|
|
Post by jfc on Jan 6, 2009 22:10:06 GMT
I have the set @ £700  The only instructions are stuck to the top of the box . If you dont have them i can take a pic for you . Oh and there is a sample of how the joint should be . |
|
simuk
Full Member
Posts: 111
|
Post by simuk on Jan 7, 2009 23:05:57 GMT
Thanks jfc
that would be great,
Simon
|
|
|
|
Post by jfc on Jan 20, 2009 15:32:07 GMT
I tried to peel the top off so i could scan it but its stuck fast . Best pic i could get so far .  |
|
|
|
Post by jfc on Jan 20, 2009 16:00:02 GMT
Like this to do your profile  And this to do your scribe   |
|
The only instructions are stuck to the top of the box . If you dont have them i can take a pic for you . Oh and there is a sample of how the joint should be .